Configuring The System As An Authoritative Ntp Server - Cisco NCS 5000 Series Manual

Configuring the System as an Authoritative NTP Server

Command or Action
or
RP/0/RP0/CPU0:router(config-ntp)#
commit
Configuring the System as an Authoritative NTP Server
You can configure the router to act as an authoritative NTP server, even if the system is not synchronized to
an outside time source.
No specific command enables NTP; the first NTP configuration command that you issue enables NTP.
Note
SUMMARY STEPS
1. configure
2. ntp
3. master stratum
4. Use one of the following commands:
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 ntp
Example:
RP/0/RP0/CPU0:router(config)# ntp
Step 3
master stratum
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
158
Purpose
• Use the commit command to save the configuration changes to the
• end
• commit
Purpose
Enters NTP configuration mode.
Makes the router an authoritative NTP server.
◦ Entering no exits the configuration session and returns the router to
EXEC mode without committing the configuration changes.
◦ Entering cancel leaves the router in the current configuration session
without exiting or committing the configuration changes.
running configuration file and remain within the configuration session.
Implementing NTP