Cisco NCS 5000 Series Manual page 186

System management configuration guide for cisco ncs 5000 series routers
Hide thumbs Also See for NCS 5000 Series:
Table of Contents

Advertisement

Configuring Frequency Synchronization on an Interface
The quality option configured here must match the globally configured quality option specified in the
Note
quality itu-t option command.
9 Exit to the global configuration mode and commit your configuration.
RP/0/RP0/CPU0:router(config-if-freqsync)# commit
Verification
To verify the configured interfaces, use show frequency synchronization interfaces command.
RP/0/RP0/CPU0:router# show frequency synchronization interfaces tenGigE 0/0/0/8
Fri Apr 7 15:06:24.123 UTC
Interface TenGigE0/0/0/8 (down)
Assigned as input for selection
Wait-to-restore time 0 minutes
SSM Enabled
Input:
Down
Last received QL: Failed
Effective QL: Failed, Priority: 100
Supports frequency
Output:
Selected source: Internal0 [0/RP0/CPU0]
Selected source QL: Opt-II,1/ST3
Effective QL: Opt-II,1/ST3
Next selection points: NCS5K_ETH_RXMUX
To verify the configurations on all line interfaces with frequency synchronization, use show frequency
synchronization interfaces brief command.
RP/0/RP0/CPU0:router# show frequency synchronization interfaces brief
Flags: > - Up
Fl
Interface
===
====================
>Sx
GigabitEthernet0/2/0/0
Dd
GigabitEthernet0/2/0/1
Sources configured as inputs is indicated by S in the Flags column.
Internal oscillators are always eligible as inputs.
Note
To verify each configured interface separately, use show frequency synchronization interfaces node-id
command.
RP/0/RP0/CPU0:router# show frequency synchronization interfaces TenGigE0/0/0/8
Interface TenGigE0/0/0/8 (shutdown)
Assigned as input for selection
SSM Enabled
Input:
Down
Last received QL: Failed
Effective QL: Failed, Priority: 100
Output:
Selected source: Internal0 [0/RP0/CPU0]
Selected source QL: Opt-II,1/ST3
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
176
D - Down
d - SSM Disabled
x - Peer timed out
QLrcv
=====
Fail
n/a
S - Assigned for selection
i - Init state
QLuse
Pri
QLsnt
Source
=====
===
=====
================
Fail
100
DNU
None
Fail
100
n/a
None
Frequency Synchronization

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents