Cisco NCS 5000 Series Manual page 160

Configuring Broadcast-Based NTP Associates
Use the broadcast command to set your networking device to send NTP broadcast packets.
Note No specific command enables NTP; the first NTP configuration command that you issue enables NTP.
SUMMARY STEPS
1. configure
2. ntp
3. (Optional)
4. interface type interface-path-id
5. broadcast client
6. broadcast [destination ip-address] [key key-id] [version number]
7. Use one of the following commands:
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 ntp
Example:
RP/0/RP0/CPU0:router(config)# ntp
Step 3 broadcastdelay microseconds
Example:
RP/0/RP0/CPU0:router(config-ntp)#
broadcastdelay 5000
Step 4
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-ntp)#
interface POS 0/1/0/0
Step 5 broadcast client
Example:
RP/0/RP0/CPU0:router(config-ntp-int)#
broadcast client
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
150
broadcastdelay microseconds
• end
• commit
Purpose
Enters NTP configuration mode.
(Optional)
Adjusts the estimated round-trip delay for NTP broadcasts.
Enters NTP interface configuration mode.
Configures the specified interface to receive NTP broadcast packets.
Go to 6 to configure the interface to send NTP broadcast
Note
packets.
Implementing NTP