Configuring Frequency Synchronization On An Interface - Cisco NCS 5000 Series Manual

Configuring Frequency Synchronization on an Interface

1
Selection point: T4-SEL-A (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 2d23h ago
Next selection points
Uses frequency selection
Selection point: T4-SEL-C (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 2d23h ago
Next selection points
Uses frequency selection
Selection point: CHASSIS-TOD-SEL (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 4w0d ago
Next selection points
Uses time-of-day selection
Selection point: NCS5K_ETH_RXMUX (0 inputs, 0 selected)
Last programmed 4d03h ago, and selection made 4d03h ago
Next selection points
Uses frequency selection
To display a summary of the frequency synchronization configuration, use show frequency synchronization
summary command.
RP/0/RP0/CPU0:router# show frequency synchronization summary
Fri Apr 7 15:06:24.123 UTC
Frequency
=========
Internal0 [0/RP0/CPU0] is driving frequency on:
0 Clock-interfaces
4 Ethernet interfaces
0 SONET interfaces
Time-of-Day
=========
Configuring Frequency Synchronization on an Interface
To configure Frequency Synchronization on an Interface, use the following procedure:
Note By default, there is no Frequency Synchronization on a line Interface. Frequency Synchronization must
be enabled globally on the router prior to configuring Frequency Synchronization on an interface.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
174
Internal0 [0/RP0/CPU0]
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
SPA scoped : None
Node scoped : T0-SEL-B
Chassis scoped: None
Router scoped : None
n/a
Frequency Synchronization
ST3 255 Available