Session Types; How To Implement Snmp On Cisco Ios Xr Software; Configuring Snmpv3 - Cisco NCS 5000 Series Manual

Implementing SNMP
In this illustration, the agent sends a trap to the manager, but the trap does not reach the manager. Because
the agent has no way of knowing that the trap did not reach its destination, the trap is not sent again. The
manager never receives the trap.
Figure 3: Trap Not Received by the SNMP Manager

Session Types

The supported session types are:
• PPPoE
• IP SUB PKT
• IP SUB DHCP

How to Implement SNMP on Cisco IOS XR Software

This section describes how to implement SNMP.
The snmp-server commands enable SNMP on Management Ethernet interfaces by default. For information
on how to enable SNMP server support on other inband interfaces, see the Implementing Management Plane
Protection on Cisco IOS XR Software module in System Security Configuration Guide for Cisco NCS 5000
Series Routers.

Configuring SNMPv3

This task explains how to configure SNMPv3 for network management and monitoring.
No specific command enables SNMPv3; the first snmp-server global configuration command (config),
Note
that you issue enables SNMPv3. Therefore, the sequence in which you issue the snmp-server commands
for this task does not matter.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
Session Types
27