Mpsoc Device Configuration; Jtag - Xilinx ZCU106 User Manual

Do NOT plug a PC ATX power supply 6-pin connector into the ZCU106 board power
CAUTION!
connector J52. The ATX 6-pin connector has a different pin out than J52. Connecting an ATX 6-pin
connector into J52 damages the ZCU106 evaluation board and voids the board warranty.
8. Slide the ZCU106 board power switch SW1 to the ON position. The PC can now be
powered on.

MPSoC Device Configuration

Zynq UltraScale+ XCZU7EV MPSoC devices use a multi-stage boot process as described in
the "Boot and Configuration" chapter of the Zynq UltraScale+ MPSoC Technical Reference
Manual (UG1085)
Table 2-4: Switch SW6 Configuration Option Settings
Boot Mode

JTAG

QSPI32
SD
Notes:
1. Default switch setting.
2. For DIP SW6, in relation to the arrow, moving the switch toward the label ON is a 0. DIP switch labels 1 through
4 are equivalent to mode pins 0 through 3.
JTAG
Vivado®, SDK, or third-party tools can establish a JTAG connection to the Zynq UltraScale+
MPSoC device through one of these provided JTAG interfaces:
• Xilinx platform USB or cable PC4 connector (J8)
• ARM 20-pin JTAG connector (J6)
• FTDI FT232HL USB-to-JTAG bridge U152 with micro-USB connector (J2)
ZCU106 Board User Guide
UG1244 (v1.0) March 28, 2018
[Ref 2]. Switch SW6 configuration option settings are listed in
Mode Pins [3:0]
0000
0010
1110
www.xilinx.com
Chapter 2: Board Setup and Configuration
(1)
Table 2-4.
Mode SW6 [4:1]
ON,ON,ON,ON
ON,ON,OFF,ON
OFF,OFF,OFF,ON
Send Feedback
21