Index - YOKOGAWA CA700-01 User Manual

3.5 Setting the Calibration Conditions of the Pressure Switch
Setting the Device Information
These items are the same as with pressure measurement. See section 3.3
Setting Measurement Conditions
Setting Measurement Functions
4.
Set the calibration target output.
Use the ▲ or ▼ key to select Function, and press ENTER.
The measurement function options are displayed.
5. Use the ▲ or ▼ key to select P SWITCH, and press ENTER.
When the source function is set to P SWITCH
When the source function is set to EXT SWITCH
Setting Sensor Type and Range (for external pressure sensor)
The Sensor Type is fixed to 16 MPa.
The Range setting is the same as with pressure measurement. See section 2.1.
Setting Unit, Averaging, and Scaling
These items are the same as with pressure measurement. See section 3.3.
Confirming the Settings
6. After entering the information, press Setting Done (F5). The settings are confirmed.
Explanation
In pressure switch calibration, on the CA700, monitor the pressure applied to the pressure switch and
measure the output switch resistance.
For the calibration conditions, set the pressure unit, averaging, and linear scaling for monitoring the
pressure.
Range, pressure unit, averaging, and linear scaling are the same as with pressure measurement. See
section 2.1.
IM CA700-01EN
Set the Measurement function.
Set the unit.
Turns averaging on and off
Turn scaling on and off and set scaling.
Confirms the settings
Set the Measurement function.
Set the sensor type(fixed to 16MPa).
Set the measurement range.
Set the unit.
Turns averaging on and off
Turn scaling on and off and set scaling.
Confirms the settings
1
2
3
4
5
6
7

Index

3-17