Setting The Tad To Answer Calls - Radio Shack TAD-1015 Owner's Manual

43-774.fm Page 22 Friday, August 13, 1999 3:14 PM
3. When you finish your message,
press . The TAD beeps,
STOP/7
plays back the message, then
beeps again.
Note: If your message is less than 2
seconds, the TAD does not recognize
it as a new message, and plays back
the previous pre-recorded message.
Re-record your message and make
sure it is longer than 2 seconds.
To delete your personal message and
use the pre-recorded
again, hold down
OGM REC/8
2 seconds until the TAD beeps. Then,
within 2 seconds, press
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer calls, press
on the base. The number of
ANSWER
currently recorded
pears on the display if you set the
TAD to announce and record, or
pears if you set it to announce only.
You can also turn the TAD on and off
from the handset. Press
the BATT LOW indicator lights green.
When the TAD announces the current
22
messages
for about
.
STOP/7
messages ap-
ap-
A
so
REMOTE
outgoing message (either a pre-
recorded message or your personal
message), press
ANSWER/6
Notes:
• If the incoming message memory
capacity has less than 5 minutes
left, the TAD announces "Remain-
ing time, xx minute(s)" when you
set the TAD to answer calls.
• If the incoming message memory
capacity is full (40 messages or
less than 1 minute left), the TAD
announces "No remaining time for
incoming messages" and does not
answer calls.
To turn off the TAD, press
on the handset or
ANSWER
base.
.
ANSWER/6
on the