Table of Contents
Advertisement
43-774.fm Page 26 Friday, August 13, 1999 3:14 PM
REMOTE OPERATION
USING THE TOLL-SAVER
When you call the TAD with
set to
(toll-saver), it answers
TIME
TS
after about two rings if you have new
messages (ones you have not listened
to). If there are no new messages, the
TAD waits for about five rings before it
answers. This gives you time to hang
up before the TAD answers so you
can avoid any long-distance charges.
ACCESSING THE TAD BY
REMOTE
While you are away from the phone's
base, you can use a touch-tone phone
or a pulse (rotary) phone with a pocket
tone dialer to enter your PIN and do
any of the following:
• Set the TAD to answer calls
• Listen to your messages
• Record a new announcement
• Record a memo
• Erase messages
• Turn the TAD off
Note: You cannot access the TAD
from another telephone on the same
line as your TAD-1015.
1. Dial your phone number and wait
for the TAD to answer.
If the TAD is not set to answer
calls, let the phone ring 10 times.
The TAD automatically turns itself
on to answer your call then turns
26
off when you hang up (unless you
set the TAD to answer calls).
RING
2. When
begins, press
2-digit PIN within 2 seconds.
The message stops, and the TAD
announces "You have XX new
message(s)" or "You have no
messages," then plays a series of
voice
through remote operation.
3. Press
press the number key for the com-
mand you want.
Press:
1
2
3
4
5
6
7
8
0
the
outgoing
message
then enter your
prompts
to
guide
, then, within 2 seconds,
To:
Repeat current mes-
sage.
Play messages and
memos.
Skip current message
during playback.
Delete current mes-
sage during playback.
Record a memo.
Set the TAD to answer/
not answer calls.
Stop playback of mes-
sages, memos, or the
outgoing announce-
ment; end recording of
memo and outgoing
announcement.
Record a new outgoing
message.
Play the voice prompts
again.
you
Advertisement
Table of Contents
