Radio Shack TAD-1015 Owner's Manual page 24

43-774.fm Page 24 Friday, August 13, 1999 3:14 PM
• If you turn the base's ringer off,
the TAD does not beep when it re-
ceives new messages. See "Turn-
ing the Base's Ringer Off/On" on
Page 14.
Press on the base, or
PLAY/SKIP
press then
REMOTE
handset. The TAD announces the
number of messages and whether the
messages are old (already listened to)
or new. Then each new message
plays, followed by the day and time it
was recorded.
When you have both old and new
messages, the TAD first plays back
only new messages. After you have
listened to the new messages, you
can listen to all messages (old then
new) by pressing
PLAY
While playing back the messages, the
display shows the number of the cur-
rent message. For example, if you
have a total of four messages (one
old, three new), pressing
plays 2 (the first new message).
If there are no messages when you
press , five beeps sound and the
PLAY
TAD announces "You have no mes-
sages."
24
Notes:
on the
PLAY/2
To skip to the next message, press
PLAY/SKIP
To play the current message again,
press
handset).
again.
Note: If you press
dis-
PLAY
seconds after a message begins play-
ing, the TAD repeats the previous
message.
• If the TAD detects a busy signal or
silence for more than 7 seconds
while recording a message, it
stops recording and releases the
call.
• When you play back messages
using the handset, the message
number does not appear on the
display.
(or on the handset).
SKIP/3
(or
REPEAT REPEAT/1
REPEAT
on the
within 2