Recording/Deleting An Outgoing Message; Setting The Record Time; Setting The Answering System To Answer Calls; Screening Calls - Radio Shack Digital Spread Spectrum Cordless Telephone with Digital Answering System Owner's Manual

43-3805.fm Page 17 Wednesday, May 17, 2000 3:48 PM
The system switches to the other message
and plays it.
RECORDING/DELETING AN
OUTGOING MESSAGE
To record your outgoing message (up to 30
seconds long), hold down
until the answering system beeps and
appears. When you finish your message,
press or
PLAY/STOP OGM
back your message.
To delete your outgoing message and use
the answering system's prerecorded mes-
sages, hold down
OGM
beeps. Then press
OGM
seconds.
SETTING THE RECORD
TIME
Set to , , or
REC TIME 1 4
how the answering system will record incom-
ing messages.
— The system plays the outgoing
1
message and lets callers leave a mes-
sage up to 1 minute long.
— The system plays the outgoing
4
message and lets callers leave a mes-
sage up to 4 minutes long.
(announcement only) — The sys-
ANN
tem plays the outgoing message but
does not let callers leave a message.
SETTING THE ANSWERING
SYSTEM TO ANSWER
CALLS
To set the answering system to answer calls,
press on the base. If the system is
ANSWER
set to record a caller's message (see "Set-
ting the Record Time"), it plays the outgoing
message and shows the number of recorded
messages. If the system is set to announce-
ment-only, it plays the outgoing message,
and
To set the system to not answer calls, press
ANSWER
off" and the message counter turns off.

SCREENING CALLS

on the base
OGM
- -
You can let the answering system answer
calls for you while you listen to the caller's
. The system plays
message through the base's speaker. If you
decide to answer the call, press
the base to answer using the speakerphone,
press
handset is off the base, or if the handset is
until the system
on the base, lift it. You can also pick up any
again within two
phone on the same line. The system stops
recording and resets to answer the next call.
RECORDING INCOMING
MESSAGES
to determine
ANN
After the answering system answers a call, it
plays the outgoing message, beeps, and
records the caller's message. Each incoming
message can be up to 1 or 4 minutes long,
depending on how you set
"Setting the Record Time"). The system's
maximum recording capacity is 18 minutes.
The system stops recording and resets to
answer the next call when:
Note: When the answering system's mes-
sage memory is full,
counter window and the system announces
"No remaining time" when you try to operate
it.
Answering System Operation
A appears.
. The system announces "Answer
on the handset to answer if the
TALK
• The caller hangs up.
• The maximum message
reached.
• The system detects a busy signal or
more than 7 seconds of silence.
• You pick up the system's handset or any
phone on the same phone line.
FL appears message
on
SPEAKER
(see
REC TIME
length is
17