Table of Contents
Advertisement
43-775.fm Page 25 Friday, August 13, 1999 3:25 PM
3. When you finish your message,
press
. The TAD beeps,
STOP/7
plays back the message, then
beeps again.
Note: If your message is less than 2
seconds, the TAD does not recognize
it as a new message, and plays back
the previous pre-recorded message.
Re-record your message and make
sure it is longer than 2 seconds.
To delete your personal message and
use
the
pre-recorded
again, hold down
OGM REC/8
2 seconds until the TAD beeps. Then,
within 2 seconds, press
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer calls, press
on the base. The number of
ANSWER
calls in the TAD's memory (or
pears on the display if you set the
TAD to announce and record, or
pears if you set it to announce only.
You can also set the TAD from the
handset. Press
LOW indicator lights green. After the
TAD announces the current outgoing
message (either a pre-recorded mes-
sage or your personal message),
press
swer calls.
Notes:
messages
for about
.
STOP/7
) ap-
0
To turn off the TAD, press
A
ap-
on the handset or
base.
REMOTE
to set the TAD to an-
ANSWER/6
• If the incoming message memory
capacity has less than 5 minutes
left, the TAD announces "Remain-
ing time, xx minute(s)" when you
set the TAD to answer calls.
• If the incoming message memory
capacity is full (40 messages or
less than 1 minute left), the TAD
announces "No remaining time for
incoming messages" and does not
let you set it to answer calls.
ANSWER
so the BATT
ANSWER/6
on the
25
Advertisement
Table of Contents
