Tablet Software Installation For Windows And Macintosh - Wacom DTU-710 Safety Instructions

Connect the AC adaptor power cable and plug the adaptor into an AC outlet.
Turn on the power switch of DTU-710. The power lamp will light blue, and then turns
orange.
Turn on your computer to start your operating system.
The maximum resolution of DTU-710 is 1280 x 1024, True Color (24 bit). As necessary,
configure the monitor control panel settings for the proper size and color resolution.
The number of colors is constrained by the performance of your computer or graphics card.
Refer to the documentation of the manufacturer for details.
If you are using analog (VGA) mode, you may also want to fine-tune the display. Please
refer to Adjusting the LCD Monitor on page 15 for more information.
To install the Wacom tablet software, turn off your computer and connect the USB cable or
serial data cable.

Tablet Software Installation for Windows and Macintosh

After connecting all cables of DTU-710, turn on DTU-710 and your computer. Allow the
operating system to fully load.
Insert the Wacom Tablet CD into the CD-ROM drive. The Wacom tablet software installer
menu should automatically display. If the menu does not display, double-click on the Install
icon (located on the CD). Follow the prompts to install the driver software.
Windows: After the driver installation is complete, make sure you can use your pen on the
tablet display to move the screen cursor.
Macintosh: After the driver installation is complete, restart your Macintosh. You will be
able to use your pen on the tablet display to move the screen cursor.
Be sure to read the R
EAD
If you have trouble in the Tablet software installation, refer to the Troubleshooting chapter in the online
Hel in the Wacom Tablet CD. You can also open the online Help from the H
P
T control panel.
COM ABLET
Precede to Customizing Your DTU-710 - The Basics.
DTU-710_EN.indd 7
M file for late braking news.
E
menu from the W -
ELP A
7
04.7.20 8:31:38 PM