Using A Pen - Wacom DTU-710 Safety Instructions

Using the Pen

Using a Pen

Pointing and Selecting
Move the pen above DTU-710 screen to position the screen cursor. The cursor instantly jumps
to the new location (absolute positioning). Press the pen tip on DTU-710 screen to make a se-
lection.
Note: If the screen cursor is not aligned with the pen tip, you will need to calibrate DTU-710.
Clicking
Tap DTU-710 screen once with the
pen tip, or touch the pen to the display
screen with enough pressure to generate
a mouse click.
Dragging
Select an object, then slide the pen tip
across DTU-710 screen to move the ob-
ject.
Removing the Side Switch
If you prefer to remove the side switch:
Firmly clasp the switch in the
middle and pull out. (Press in on the
rubberized grip in order to better grasp
the switch.)
Important : Do not remove the
switch by prying it from either
end as this may damage your
Pen.
Remove the pen tip cone by turning it
counterclockwise.
Pull the grip forward over the pen tip.
NEVER adjust the trimmer capacitor
that became visible as it is fine tuned.
When using the pen without the side
switch, always istall the optional grip
in order to protect the trimmer capaci-
tor.
Install the optional grip by aligning the
pen case rails with the grooves inside
the grip and pushing the grip over the
pen tip.
Replace the pen tip cone by turning it
clockwise onto the pen.
To reinstall the side switch, reverse the above procedure.
14
DTU-710_EN.indd 14
Double-Clicking
Press the upper side switch (Windows systems)
or quickly tap DTU-710 screen twice in the same
place with the pen tip. Double-clicking is easier
when the pen is perpendicular to the tablet screen.
Erasing
In supporting applications, the pen's eraser works
like the eraser on a pencil. In text applications, use
the eraser to select text, then lift the eraser from
the tablet to delete the text.
Rubber Grip
Sectional
04.7.20 8:32:07 PM