Adjusting The Lcd Monitor; Working With Osd (On Screen Display) Menu - Wacom DTU-710 Safety Instructions

Adjusting the LCD Monitor

Factory Presets, Multi-sync, and User Settings
Factory Presets: To display images with the best quality (based on the incoming signal),
DTU-710 comes with a number of factory default standard display modes.
Multi-Sync: When connected as a VGA display, DTU-710 attempts to automatically
synchronize to the incoming signal. Multi-Sync functions if the horizontal frequency is
between 30 to 80 kHz and the vertical frequency is between 50 to 75 Hz. If DTU-710 does not
automatically synchronize with the incoming signal, you can use the OSD Reset Auto Adjust
option to initiate display synchronization. If necessary, further screen display adjustments can
be manually made using the On Screen Display (OSD) controls.
User Settings: When you manually set the display using the On Screen Display (OSD)
function, the settings are stored within DTU-710 for use the next time the unit receives a
similar signal. This is applicable to all display modes.

Working with OSD (On Screen Display) Menu

To open the main MENU, press the MENU ( ) button.
Use the + ( ) or - ( ) butto0ns to select an option. When the option you want to adjust is
highlighted, press the ENTER ( ) button. The current settings and adjustment sub-menu for
that option will appear.
Use the + ( ) or - ( ) buttons to adjust the option settings.
When you have made your changes, press the ENTER ( ) button to save. To exit, press
the MENU ( ) button. All settings are automatically saved when the OSD menu closes.
Contrast
Select to increase or
decrease image contrast.
Brightness
Select to increase or
decrease image brightness.
DTU-710_EN.indd 15
Phase (VGA only)
Select to reduce or
eliminate horizontal
distortion lines. ☞ P17
To automatically adjust,
use the RESET option.
Pitch
(VGA only)
Celect to reduce or
eliminate vertical distortion
lines. ☞ P17
To automatically adjust, use
the Reset option.
15
04.7.20 8:32:19 PM