Caring For Your Dtu-710; Cleaning; Replacing The Pen Tip - Wacom DTU-710 Safety Instructions

Caring for DTU-710

Cleaning

T o clean the DTU-710 casing, use a soft cloth with mild detergent (such as dish washing
liquid) diluted with water. Do not use paint thinner, benzine, alcohol, or other organic solvents
to clean DTU-710 casing or pen.
To clean the display screen, use a soft, dry cloth. If necessary, slightly moisten the cloth
with water and try again. When cleaning, apply only a light amount of pressure to the display
screen and do not make the surface wet. Do not use detergent to clean the display screen; this
may damage the coating on the screen. Please note that damage of this kind is not covered by
the manufacturer's warranty.

Replacing the Pen Tip

The pen tip will wear with normal use. When the nib gets too short, you can replace it with
one of the extra nibs that came with your pen. If the pen tip wears and becomes angular, it
may damage the coating on the cover glass of DTU-710 Interactive Pen Display. To avoid this,
periodic nib replacement is recommended.
To remove the old nib:
Clasp it with a pair of tweezers or
similar instrument and pull the old
nib straight out of the pen.
CAUTION
Prevent your children from swallowing the pen nib or side switch. The pen nib or
side switch may accidentally be pulled out if children are biting on them.
DTU-710_EN.indd 19
To insert a new nib:
Slide it straight into the barrel of the
pen. Firmly push the nib until it stops.
The new nib will slide into the correct
position.
19
04.7.20 8:32:51 PM