Calibrating the Tablet
You will need to calibrate the tablet in order to line up the screen cursor position with the
position of the pen on DTU-710. This is required to adjust for parallax caused by the display
screem overlay. After setting the tablet in its working position, follow the procedure below to
calibrate the tablet.
From the Wacom Tablet
Control Panel, select the
Calibration tab.
I f y o u a r e w o r k i n g
with multiple monitors,
select the Monitor that
c o r r e s p o n d s t o t h e
tablet's LCD display.
Click on the Calibrate...
b u t t o n t o d i s p l a y t h e
m o n i t o r c a l i b r a t i o n
screen.
H o l d t h e p e n a s y o u
normally do, and use the
pen tip to click on the
cross-hairs in the upper-
left corner.
Then click on the cross-
hairs that are displayed
in the lower-right corner.
(For Windows systems,
you will need to click
A p p l y o r O K f o r t h e
changes to take effect.)
Note: The calibration
setting applies to all
applications.
DTU-710_EN.indd 9
9
04.7.20 8:31:42 PM