Sundance Spas Hamilton Owner's Manual page 26

780 Series
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
Check water temperature carefully before entering hot tub!
!
Excessive water temperature can cause burns, welts and
body temperature to rise, hyperthermia (over-heating).
Decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable at the levels recommended on the inside cover of
this manual.
9. Add 2.5 ounces (71 g) of sodium dichlor for every 100 gallons (378
Liters) of water. Refer to the table (page 20) for approximate water
fill volume by model.
CAUTION: RISK OF PERSONAL INJURY OR Spa DAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash,
and void the manufacturer warranty for your spa.
Water Fill Capacity
Model
Bristol................................. 350 Gal (1,325 L) ................................ 9.0 oz
Chelsee ............................. 400 Gal (1,514 L) .............................. 10.0 oz
Dover ................................. 230 Gal (871 L) ................................... 6.0 oz
Hamilton ............................ 393 Gal (1,488 L) .............................. 10.0 oz
Hanover ............................. 355 Gal (1,344 L) ................................ 9.0 oz
Montclair ............................ 310 Gal (1,173 L) ................................ 8.0 oz
*Use average fill volume for chemical maintenance
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
pillows and plastic knobs from chemical attack. If
spa is indoors, open doors and windows for proper
ventilation. Turn on all spa jets pumps for one hour,
open all air controls, and place all massage selector knob(s) in their
center "combo" position as shown (right).
Note: You will need to press the jets pump button(s) every 20 minutes
since these functions have an automatic 20 minute time-out function that
turns them off.
Page 20
RISK OF PERSONAL INJURY.
Average
Fill Volume*
Sodium
dichlor