Channel - Akai DPS24 Operator's Manual

CHANNEL

In the main MIXER page, pressing CHANNEL (F1) will show something like this screen:
This shows the settings for a selected channel.
The page is designed so that you can use the Q-Channel to set the main parameters (pan, EQ, sends, etc.) and the Q-
Link controls to set the others. However, it is also possible to navigate the 'channel' window (i.e. pan, level, EQ, FX
parameters) using the CURSOR keys to set precise values from the numeric keypad or using the DATA +/- keys. You
can also set values using the DATA ENTRY Q-Link control on Q6.
The Q-LINK parameters on the right of the page are as follows:
INPUT SOURCE
NOTE : In the DISK TRACK pages, this parameter is labelled RECORD SOURCE .
PHASE INVERT
ATTENUATION
METER
Here, you can select the input source. The choices are:
ADC 1-12 FX 1 L
Digital In L FX 1 R
Digital In R FX 2 L
Aux In L FX 2 R
Aux In R FX 3 L
2-Track L FX 3 R
2-Track R FX 4 L
ADAT 1 - 8 FX 4 R
In this way, you can patch any analogue or digital audio source to any channel.
Inverts the phase of the channel.
A simple attenuator to compensate for any excessive gain boosts in the EQ.
This allows you to set where in the audio chain you will view the meter shown to the
right of the fader. The options are PRE-EQ, PRE-FADE and POST-FADE.
METRO(nome)
MIXER
59