Powering Up The Dps24 - Akai DPS24 Operator's Manual

POWERING UP THE DPS24

Ensuring that your monitor amplifier's master level control is turned down, switch the DPS24 on using the rear panel
POWER switch. You will see this screen during power up:
Followed shortly afterwards by this screen:
Once the disk scan has completed, you should see the icons for the installed drive(s) appear at the bottom of the
screen. Typically, these will be the Internal HD and maybe a CD drive (if the option is installed).
NOTE : If your LCD appears blank during power up, check to make sure that the LCD CONTRAST control
is not set to minimum. The contrast can be turned down such that the screen can appear almost completely blank
from some viewing angles.
If your DPS24 does not power up as described above - for example, you get an error message saying "NO DRIVES
DETECTED" or your CD drive (if installed) doesn't show up at the bottom of the screen or whatever - you should
contact your AKAI professional dealer or technical support immediately.
Assuming your DPS24 does power up properly, you should press MAIN SCREEN (or whichever mode you wish to
use).
POWERING UP THE DPS24
39