Fx/Aux Setup - Akai DPS24 Operator's Manual

FX/AUX SETUP

Pressing FX/AUX SETUP in the main MIXER page shows this screen:
Here you can set up the configuration of the FX/Aux busses. The Q-Link functions are:
FX/AUX 1/2
NOTE : There is not much point in setting these sends to stereo when using the internal effects as all the
internal effects have a mono input. However, you could use a stereo send and use the pan control (FX/Aux 2) to
'morph' between the two channels. That you can also automate the movement of the pan control means that some
special effects could be created.
FX/AUX 1 >
FX/AUX 2 >
Allows you to configure FX/AUX 1/2 as two mono sends or one stereo send. When
configured as STEREO, the graphics change:
The control normally used to set the send level for FX1/Aux 1 now sets the level for the
stereo send and the control normally used to set the send level for FX/Aux 2 now sets
the send's stereo pan position.
Allows you to route the FX/Aux send to the INTERNAL FX or to the AUX busses.
The send may also be switched off.
As for FX/Aux 1 but, of course, for FX/Aux 2
MIXER
67