Talkback - Akai DPS24 Operator's Manual

MIXER
FX/AUX 3/4 are virtually identical to FX/AUX 1/2 except that they can also be routed to the STUDIO L and/or
STUDIO R bus. Typically, these are used to set up a foldback monitoring system for recording in a separate studio
area.
Using the mono/stereo option for the sends, you can create various different foldback configurations and you can
have the following setups:
• 1 x mono foldback mix on either AUX 3 or AUX 4.
• 2 x independent mono foldback sends each with a separate mix on each send.
• 1 x stereo foldback mix with control of level and pan for each channel allowing you to set a stereo mix in the
STUDIO outputs.
NOTE : When STUDIO L is selected, AUX 3's output is muted. Similarly, when STUDIO R is used, AUX 4's
output is muted.

TALKBACK

The DPS24's internal talkback mic is permanently hardwired to the STUDIO outputs and is activated using the
TALKBACK button located above the MASTER fader.
NOTE : The talkback mic only appears at the STUDIO L and/or R outputs are used/enabled in the FX/AUX
SETUP page. The talkback mic will not be heard through the STUDIO outputs if busses 3 and/or 4 are routed
to the internal effects or the AUX bus.
68