Toyota Land Cruiser 200 2010 Owner's Manual page 31

■
Switching the door unlock function
If it is possible to set which doors the entry function unlocks.
STEP 1
Turn the "ENGINE START STOP" switch OFF.
STEP 2
When the indicator on the key surface is turned off, press and hold
the key.
The setting changes each time an operation is preformed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat
Multi-information
display
STEP 3
Unlock the doors using the electronic key and open one of the
doors.
If a door is not opened within 60 seconds after
the doors will be locked again and the alarm will automatically be
set.
In case that the alarm is triggered, immediately stop the alarm.
(P. 98)
L/C200_U (OM60G31U)
1-2. Opening, closing and locking the doors
or for approximately 5 seconds while pressing
.)
STEP 2
Unlocking function
Hold the driver's door han-
dle to unlock only the
driver's door.
Hold either door handle to
unlock all doors.
on
Beep
Exterior: Beeps three
times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed,
31
1