Install Rail Brackets Using The Adapter Hardware (For Threaded Hole Racks); Adapters - Dell Data Domain DD9500 Hardware Overview And Installation Manual

Install rail brackets using the adapter hardware (for threaded hole racks)

Note
If you are using a rack with square or round holes, go to
l
Data Domain racks (for square or round hole racks)
Only use this procedure if your rack has tapped holes that are M5, M6, 10/32, or
l
12/24.
The adapter hardware is shipped in the rack mount kit.
l
You will need a long handled screwdriver with a shank diameter less than 7.0 mm
l
and the wrench (included in the kit) to tighten the nuts.
Procedure
1. Locate the two adapters from the rail kit.
Figure 25 Adapters
1. Long adapter
2. Short adapter
2. Attach the long adapter to the front of each rail using M5 screws.
Install rail brackets using the adapter hardware (for threaded hole racks)
Install the System in the Rack
Install rail brackets on the
on page 40 section.
43