Insert Screw In The Back - Dell Data Domain DD9500 Hardware Overview And Installation Manual

3. From the rear of the system, hold the bracket against the inside of the rack
posts. Align the rear guide pin and slide the bracket towards the front. The
guide pins can help to temporarily hold the rack mount bracket in place. Attach
the bracket to the rear of the rack using the furnished screws. There are five
screw holes. The picture shows two screws attached to the rear rack post.
Figure 22 Insert screw in the back
CAUTION
If the bracket is mounted in holes that are not vertically aligned from front
to back, the bracket may be damaged and mounting will not be secure.
4. Pull the adjustable sliding part of the bracket towards the front until it is close
to, but not touching, the front of the rack.
Install rail brackets on the Data Domain racks (for square or round hole racks)
Install the System in the Rack
41