The Log Viewer Screen - ZyXEL Communications SBG5500-A User Manual

Table 96 Syslog Severity Levels
CODE
4
5
6
7

13.2 The Log Viewer Screen

Use the Log viewer screen to see the system logs. Click Configuration > Log / Report > Log Viewer to
open the following screen.
Figure 154 Configuration > Log / Report > Log Viewer
The following table describes the fields in this screen.
Table 97 Configuration > Log / Report > Log Viewer
LABEL
Show (Hide) Filter
Display
Priority
Source IP
Source Interface
Chapter 13 Log / Report
SEVERITY
Warning: There is a warning condition on the system.
Notice: There is a normal but significant condition on the system.
Informational: The syslog contains an informational message.
Debug: The message is intended for debug-level purposes.
DESCRIPTION
Click this button to show or hide the filter settings.
If the filter settings are hidden only Display filter is available.
If the filter settings are shown, the Display, Priority, Source Address, Destination IP Address,
Source Interface, Destination Interface, Protocol, Keyword, Search and Reset fields are
available.
Select the type of log message(s) you want to view. You can also view All Logs at one time,
or you can view the Debug Log.
This displays when you show the filter. Select the priority of log messages to display. The log
displays the log messages with this priority or higher. Choices are: any, emerg, alert, crit,
error, warn, notice, and info, from highest priority to lowest priority. This field is read-only if the
Display field is set to Debug Log.
This displays when you show the filter. Type the source IP address of the incoming packet
that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the source interface of the incoming packet that
generated the log message.
SBG5500 Series User's Guide
216