Fluke DTX-1800 Technical Reference Handbook page 260

DTX Series CableAnalyzer
Technical Reference Handbook
To use the FindFiber function in Smart Remote mode:
1 Turn the rotary switch to SETUP; then select Fiber Loss.
2 Select Remote End Setup; then select Smart Remote.
3 Clean all connectors; then make the connections
shown in Figure 8-25.
4 Turn the rotary switch to MONITOR; then select
FindFiber.
8-52
5 Try various connections to the patch panel with the
main tester's INPUT fiber until the input fiber's status
shows Connected.
6 Then try various connections with the main tester's
OUTPUT fiber until the output fiber's status shows
Connected.
Figure 8-26 shows the main tester results for Smart
Remote mode.