Fluke DTX-1800 Technical Reference Handbook page 155

1
10
9
A
The percentage of the HDTDR test signal reflected back to
the tester. See Figure 6-4. Reflections plotted are adjusted
to compensate for insertion loss. This means the plot
represents the magnitudes of signals at the reflection
source.
B
The beginning and end of the cabling under test. For a
permanent link, the plot shows some of the permanent
link adapter cable before and after the cabling under test.
3
2
4
5
6
8 7
amd97f.eps
Figure 6-3. HDTDR Plot (permanent link adapters used)
Diagnosing Copper Cabling Faults
C
Horizontal and vertical magnification levels for the
plot. In zoom mode, use
zoom in or out at the cursor's location.
D
The distance to the end of the cabling.
E
The cursor and the distance to the cursor from the
tester. In cursor mode, use
F
The reflection percentage at the cursor's location.
G
Shows the reflection plots by pair. Press
to the plot of all pairs.
H
Toggles the display between zoom and cursor modes.
I
Sets or clears the measurement marker. See
J
The distance between the measurement cursors.
To use the measurement cursors (with the plot in
cursor mode):
J
1 Press Clear Mark if necessary; then use
to move the cursor to the beginning of an area
AD
of interest. Use
area if desired.
J
2 Press Set Mark; then use
second cursor to the end of the area of interest.
6
The HDTDR Analyzer
BC AD
and to
BC
to move the cursor.
I
to return
J
.
BC
to zoom in on the
BC
to move the
6-11