Assembly - ProForm 831.215010 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench
screwdriver
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free 1-888-533-1333.
M8 Split
Washer (50)–7
M8 x 37mm Button
Bolt (52)–4
M8 x 25mm Button
Screw (51)–2
1. Attach the Rear Stabilizer (16) to the Frame (1) with
two M10 x 112mm Carriage Bolts (43) and two M10
Nylon Locknuts (63).
.
M8 Nylon
Locknut (65)–8
M4 x 12mm
M10 Nylon
Screw (60)–2
Locknut (63)–4
M8 x 90mm Button
Screw (41)–1
M10 x 112mm
Carriage Bolt (43)–4
1
43
16
5
and Phillips
M4 x 16mm
Screw (57)–4
1
63