Table of Contents
Advertisement
ASSEMBLY
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed.
Assembly requires the included allen wrench
spanners
1. As you attach the Handlebar Post (19), be careful
not to pull on the Resistance Cable (6). If the
Resistance Cable is pulled further out of the Frame
(13), it will be difficult to push it back in. The
Handlebar Post will then be difficult to assemble
and the resistance knob may not function properly.
Hold the Handlebar Post (19) near the Frame (13)
as shown. Feed the Resistance Cable (6) and the
Reed Switch Wire (4) into the Frame, and then slide
the Handlebar Post into the Frame. Be careful not
to pinch the Resistance Cable or the Reed
Switch Wire. Attach the Handlebar Post with three
M10 x 22mm Button Head Bolts (55) and three M10
Lock Washers (61).
The Console (5) requires one 9-volt battery (not
included). An alkaline battery is recommended. Refer
to the inset drawing. Locate the battery door on the
back of the Console. Slide the battery door to the left
and open it as shown. Press a battery into the bat-
tery clip and insert the battery into the Console.
Close the battery door and slide it to the right.
2. Make sure that there are Adjustable Endcaps (25)
on the ends of the Front Stabiliser (27).
Hold the Front Stabiliser (27) against the saddle on
the front of the Frame (13). Make sure that the
Front Stabiliser is turned so the Wheels (26) are
not touching the floor. The Wheels should not
touch the floor unless the exercise bike is tipped for
moving. Attach the Front Stabiliser with two M10 x
75mm Carriage Bolts (54) and two M10 Nylon
Locknuts (44).
3. Make sure that there are Round Endcaps (15) on
the ends of the Rear Stabiliser (16).
Hold the Rear Stabiliser (16) against the saddle on
the rear of the Frame (13), with the square holes
facing away from the saddle. Attach the Rear
Stabiliser with two M10 x 75mm Carriage Bolts (54)
and two M10 Nylon Locknuts (44).
All manuals and user guides at all-guides.com
.
, a phillips screwdriver
1
4
6
61
55
2
54
26
25
3
44
13
15
5
and two adjustable
5
19
55
Battery
Door
61
Battery
55
Clip
13
Battery
25
26
27
56
13
44
15
16
54
5
Square
Holes
Advertisement
Table of Contents
