Assembly - ProForm XP Whirlwind 280 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench and a Phillips
screwdriver .
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M6 Locknut M8 Locknut M8 Split Wave Washer M8 Washer M10 Split
(78)–2
(56)–4 (66)–4 Washer (72)–4 Washer (54)–3
(85)–2
M4 x 4.5mm
M4 x 16mm M6 x 38mm Button M8 x 16mm M10 x 17mm
Screw (70)–1
Screw (77)–4 Bolt (57)–4 Screw (84)–2 Screw (55)–3
M10 x 22mm M10 x 78mm Screw (65)–2
Screw (4)–5
5