Assembly - ProForm 210 CSX User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 5.
1. Go to www.iconsupport.eu on your computer
and register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Service
• allows us to notify you of upgrades and offers
Note: If you do not have internet access, call
Customer Service (see the front cover of this
manual) and register your product.
2. If there are shipping brackets (not shown) on the
rear of the Frame (1), remove the screws from
the shipping brackets and discard the screws
and the shipping brackets.
Identify the Rear Stabilizer (3), which has a
Leveling Foot (28) near each end.
Set a sturdy piece of packing material (not
shown) under the rear of the Frame (1).
Orient the Rear Stabilizer (3) as indicated by the
sticker. Attach the Rear Stabilizer to the Frame
(1) with two M10 x 68mm Screws (44).
Then, remove the packing material.
In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
2
3
28
44
28
6
1