Attaching The Wireless Ap 7220 To The Base Plate Adaptor - Nortel 7220 Installing Manual

DRAFT March 24th-2005
Figure 6 Wiring the Wireless AP 7220 to the mechanical support inner arm
23 Attach the Wireless AP 7220 black wire to the correct position on the terminal
strip. Connect the neutral wire to the neutral position on the terminal strip and
the GND (green wire) to the GND position on the terminal strip.

Attaching the Wireless AP 7220 to the base plate adaptor

24 With wiring complete, slide the cylindrical housing (with Wireless AP 7220
attached) over the inner arm.
25 Align and secure the cylindrical housing with the two set screws located at the
base.
26 Verify the alignment of the vertical and horizontal and adjust if required.
To adjust the alignment, loosen the four adjustment screws on the base plate
adaptor and align the unit in the vertical or horizontal as required.
Tighten the four adjustment screws to secure the alignment.
Installing the Nortel Wireless Access Point 7220
9