Installing An External Co-Linear Antenna - Nortel 7220 Installing Manual

DRAFT March 24th-2005
10
27 To complete the installation, securely tighten all anti-rotation screws and
adjustment screws. Ensure the unused ¾ NPT port is capped securely with the
plug provided.
If you are installing external co-linear antennas, proceed to the section
"Installing an external co-linear
If you are not installing external co-linear antennas, skip to the section
"Verifying correct operation through the LED indicators

Installing an external co-linear antenna

28 If you have a Wireless AP 7220 with integrated 2.4 GHz antennas instead of
co-linear antennas, skip to step 36.
29 Screw the co-linear antenna firmly onto the Wireless AP 7220 base antenna
connector.
Figure 7 Attaching the co-linear antenna
30 Slip the protective rubber boot over the antenna and 3/4 of the way to its base.
31 Apply protective grease around the underside of the boot to ensure a good
seal.
Note:
Nortel Networks recommends Dow Corning* 111 silicon for use as a protective
grease.
318527-A Rev 01
antenna.