Completing The Wireless Ap 7220 Preparation - Nortel 7220 Installing Manual

DRAFT March 24th-2005
15 Attach the connector to the Ethernet jack at the base of the Wireless AP 7220
@ NAP unit.
Figure 5 CAT5 connectorized cable end
16 Feed the power cable back up through the main support pipe until it emerges
from the cylindrical housing.
17 Replace the metal baseplate cover of the Wireless AP 7220 @ NAP by
pivoting shut the three tabs used to hold the cover in place.

Completing the Wireless AP 7220 preparation

18 Feed the Wireless AP 7220 AC wire (and, in the case of a Wireless AP
7220@NAP, the Ethernet cable) into the ¾ NPT port and up through the
cylindrical arm.
19 Screw the Wireless AP 7220 to the cylindrical arm until secure (do not over
tighten).
The wiring should extend beyond the cylinder mount to facilitate wiring to the
terminal strip located on the inner arm.
The Wireless AP 7220 and cylindrical arm are now ready to attach and wire to the
base plate adaptor on the pole.
Installing the Nortel Wireless Access Point 7220
7
Ethernet connector