Regulatory Statements - Nortel 7220 Installing Manual

FINAL April 8th-2005
3

Regulatory Statements

This device is designed for installation and use in the USA, Canada, China and Taiwan regulatory rules. For operation in
other countries, please consult Nortel Networks.
This device contains one radio operating in the 2.4 GHz band and one radio operating in the 5 GHz bands in
point-to-point fashion.
Regulatory statements pursuant to CFR 47 Part 15 for the United States
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The installation and operation of this device shall be in strict compliance with the manufacturer's instructions for its
installation and use. Any changes in the installation, or modification of the device or of its optional accessories that are
not expressly approved by the manufacturer and the party responsible for compliance could void the user's authority to
operate the device.
Only those optional accessories listed in the operating manual shall be used with this device. The use of any other
accessories (including antennas) will void the warranty and the user's authority to operate the device.
The manufacturer is not responsible for interference to other radio systems caused by the use of this device or by any
unauthorized modification to the device or its associated antennas. The manufacturer assumes no liability for any
damage or violation of regulations arising from the use of the device.
This device is designed to be installed by professionals trained in its installation and who are responsible for compliance
with the relevant regulations.
This device is designed for installation in fixed locations only.
This device is not designed for direct connection to the public switched telephone network.
Note: The use of external RF amplifiers with this device is not permitted by the regulations of the FCC.
This unit is not a consumer product and requires professional network planning and installation. As such, this device is
limited for use with approved antennas only.
Note: The use of non-approved antennas, tampering with, or deviating from the approved deployment configurations is
strictly prohibited and could result in FCC/IC (Industry Canada) regulatory violations.
Installing the Nortel Wireless Access Point 7220