Table of Contents
Advertisement
DRAFT March 24th-2005
6
Figure 3 Open cabling compartment
12 Remove the Ethernet port protective cover from the cabling compartment.
Figure 4 Remove Ethernet port protective cover
Ethernet port cover
13 Pull back the unattached end of the AC power cable from the central support
pipe until it is free of the shaft. This will make it easier to feed the Ethernet
cable up through the support pipe.
Note:
Do not disconnect the AC power connector from the Wireless AP 7220 @ NAP.
Note:
The CAT5 cable has a connector at one end. This connector attaches to the
Ethernet jack at the base of the Wireless AP 7220 @ NAP unit.
14 Slide the non-connectorized end of the CAT 5 Ethernet cable up through the
main support pipe of the Wireless AP 7220 @ NAP and out of the side hole of
the cylindrical arm. This cable will be used to provide a wired connection to
the NAP.
318527-A Rev 01
Advertisement
Table of Contents
