Event Memory - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

event memory

To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
memory threshold, use the event memory command. To remove the memory event criteria, use the no
form of this command.
Syntax Description
critical
minor
severe
Defaults None
Command Modes
Embedded event manager configuration mode
Command History Release
5.0(3)U3(1)
Usage Guidelines This command does not require a license.
Examples
This example shows how to specify that an EEM applet runs when a memory threshold is exceeded:
switch# configure terminal
switch(config) event manager applet cli-event
switch(config-applet)# event memory critical
switch(config-applet)#
OL-29557-04
event memory [critical | minor | severe]
no event memory [critical | minor | severe]
Specifies a critical alert.
Specifies a minor alert.
Specifies a severe alert.
Modification
This command was introduced.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
event memory
-SM-63