Ntp Disable - Cisco nexus 3000 series Command Reference Manual

ntp disable

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
ntp disable
To disable Network Time Protocol (NTP), use the ntp disable command. To reenable NTP, use the no
form of this command.
Syntax Description
ip
ipv6
Defaults Enabled
Command Modes
Interface configuration mode
Command History Release
6.0(2)U(2)1
Usage Guidelines This command does not require a license.
Examples
This example shows how to disable NTP:
switch# ntp disable
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-138
ntp disable {ip | ipv6}
no ntp disable {ip | ipv6}
Disables IPv4 on the interface.
Disables IPv6 on the interface.
Modification
This command was introduced.
Chapter System Management Commands
OL-29557-04