Removing And Replacing Usb Flash Memory Stick; Removing And Replacing A Dimm - Cisco ASR 1002-HX Removing And Replacing

Removing and Replacing FRUs
The power supply LEDs illuminate green.

Removing and Replacing USB Flash Memory Stick

The contains USB ports for a flash memory stick to store configurations or Cisco IOS XE consolidated
packages.
Caution Do not remove a USB Flash memory stick when issuing a file access command or a read/write operation to
the Flash memory stick when it is processing. The router might reload or the USB Flash memory stick may
get damaged. Prior to the removal of the USB device, check to see if the USB activity LED on the front panel
is flashing.
To remove and then replace a USB flash memory stick, follow these steps:
Procedure
Step 1 Pull the flash memory stick from the USB port.
Step 2
To replace a Cisco USB Flash memory stick, insert the module into USB port 0 or 1. The Flash memory stick
can be inserted only in one way, and can be inserted or removed regardless of whether the router is powered
up or not.

Removing and Replacing a DIMM

This section describes how to replace the DIMMs on the .
You might have to upgrade a DIMM for the following reasons:
• You have upgraded to a new Cisco IOS feature set or release that requires more memory.
• You are using very large routing tables or many protocols.
The DIMM component is keyed and slotted for easier connection.
Removing a DIMM from a Cisco ASR 1001-HX Router
Before you begin
Perform the following steps before you begin the process of removing and replacing a DIMM from a Cisco
ASR 1001-HX Router:
• Use an ESD-preventive wrist strap.
• Back up the data that you want to save.
Removing and Replacing USB Flash Memory Stick
Removing and Replacing FRUs
9