Event Track - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

event track

To specify the event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of
an object tracking subsystem report for the specified object number, use the event track command. To
remove the report event criteria, use the no form of this command.
Syntax Description
tag tag
object-id
state
any
up
down
Defaults None
Command Modes Embedded event manager configuration mode
Command History Release
5.0(3)U3(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when the state of a tracked object changes:
switch# configure terminal
switch(config)# event manager applet tracking-applet
switch(config-applet)# event track 20 state down
switch(config-applet)#
OL-29557-04
event track [tag tag] object-id state {any | up | down}
no event track [tag tag] object-id
(Optional) Identifies this specific event when multiple events are included in the
policy.
Tracked object number. The range from 1 to 500.
Specifies that the tracked object transition causes an event to be raised.
Specifies an event is to be raised when the tracked object transitions to or from
any state.
Specifies an event is to be raised when the tracked object transitions from a down
state to an up state.
Specifies an event is to be raised when the tracked object transitions from an up
state to a down state.
Modification
This command was introduced.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
event track
-SM-75