Communication; Locating The Communication Bays - Powerware 9315 UPS Operation Manual

Chapter 7
This chapter describes the communication features of the Powerware 9315 UPS and
provides information about connecting hardware and using Terminal mode.

7.1 Locating the Communication Bays

The Communication Panel inside the UPS contains a DB−9 and DB−25 serial port. The DB−9
port provides a computer interface to a Remote Monitor Panel, Relay Interface Module, or
Supervisory Contact Module. The Communication Panel also contains terminals (TB1 and
TB2) for connecting your equipment to the UPS.
The X−Slot communication bay, used for optional X−Slot cards, allows the UPS to
communicate in a variety of networking environments and with different types of devices.
Figure 7-1 shows the location of these items inside the UPS.
9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev G www.powerware.com
EATON Powerware
®

Communication

NOTE The X−Slot communication bay is connected internally to the DB−25 port by
default; the DB−25 is disabled for other uses. Contact your Eaton service representative
to purchase, install, and set up an external modem or an internal X−Slot Modem Card.
7−1