Honda FIT 2014 Owner's Manual page 326

12/04/18 15:10:49 42TF2C00_326
Checking and Replacing Fuses
If something electrical in your
vehicle stops working, the first thing
you should check for is a blown fuse.
Determine from the chart on pages
324 326 , or the diagram on the
−
fuse box lid or the fuse label, which
fuse or fuses control that component.
Check those fuses first, but check all
the fuses before deciding that a
blown fuse is not the cause. Replace
any blown fuses and check if the
device works.
1. Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
2. Remove the cover from the fuse
box.
BLOWN
3. Check each of the large fuses in
the under-bonnet fuse box on the
12 volt battery by looking through
the top at the wire inside.
Replacement of these fuses should
be done by your dealer.
FUSE
BLOWN
4. Check each of the large fuses in
the interior fuse box by looking at
the wire inside. Removing these
fuses requires a Phillips-head
screwdriver.
CONTINUED
Taking Care of the Unexpected
Fuses
321