Honda FIT 2014 Owner's Manual page 272

12/04/18 15:03:48 42TF2C00_272
Replacing a Front Turn Signal
Light Bulb
1. Open the bonnet.
The front turn signal light is next
to the headlight bulb. When
replacing the right bulb, first
remove the windscreen washer
reservoir. Use a flat-tip
screwdriver to remove the holding
clip from the reservoir.
HOLDING CLIP
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn anticlockwise.
3. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
4.
5.
6.
BULB SOCKET
Lights
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
(Right side)
Put the windscreen washer
reservoir back in place. Install the
holding clip. Lock it in place by
pushing on the centre.
Maintenance
267