Close Front Door - Lexmark MX310 User Manual

Troubleshooting
Close flatbed cover and load originals if restarting job [2yy.xx]
From the printer control panel, try one or more of the following:
•
Select Scan from automatic feeder to continue scanning from the ADF immediately after the last
successful scan job.
•
Select Scan from flatbed to continue scanning from the scanner glass immediately after the last
successful scan job.
•
Select Finish job without further scanning to end the last successful scan job.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further
for copying, faxing, or e-mailing.
•
Select Cancel job to clear the message and cancel the scan job.
•
For non‑touch‑screen printer models, press

Close front door

Close the front door of the printer.
Complex page, some data may not have printed [39]
Try one or more of the following:
•
From the printer control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job. For non‑touch‑screen printer models, press
•
Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different
printer model.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models,
press to confirm.
to confirm.
to confirm.
178
to confirm.