Longhand Programming Mode - Avaya 4620 User Manual

5620user

Longhand Programming Mode

1. Press Admin or
2. Pressing Expl?
3. Press Next
4. If the function requires some data to be entered, [ is shown at the bottom of the display. Enter the
data using the normal telephone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each
key.
6. Use the and
7. Select the display key against which to program the new function by pressing that
• Caution: Do not select the slot used for the Admin function. Replacing this function will
lock the phone for further programming until reset through the telephone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
• Press
• Press
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press the
edge of the display.
• Press Repla
display then shows BUTTON PROGRAMMED! as above.
• Press Keep
• Press Delete
4620/5620 Phone User Guide
IP Office
Admin 1. See Display Key Programming. .
to switch to longhand programming mode.
until the required function required is shown, then press Selct
keys to move between the pages of display keys.
EXIT to end programming.
Cont to continue programming other functions.
and keys until Repla, Keep and Delet are shown along the right-hand
to replace that existing function with the one just programmed. The
to keep the existing function and forget the function just programmed.
to delete the existing function and forget the function just programmed.
.
Issue 2d (15th September 2005)
and
or key.
Page 28