Longhand Programming Mode - Avaya 4610 User Manual

7.4 Longhand Programming Mode

1. Press Admin or
2. To switch to longhand programming mode, press Expl?
3. Press Next until the function required is shown, then press Selct
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the
normal phone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each
6. To move between the pages of display keys, press
7. To select the display key against which to program the new function, press
Caution
· Do not select the slot used for the Admin function. Replacing this function will lock the phone for further
programming until reset through the phone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
To end programming, press
·
To continue programming other functions, press
·
9. If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press
until Repla, Keep and Delet are shown along the right-hand edge of the display.
To replace that existing function with the one just programmed, press Repla
·
displayed.
To keep the existing function and forget the function just programmed, press Keep
·
To delete the existing function and forget the function just programmed, press Delete
·
4610/5610 Phone
IP Office
Admin 1.
PHONE/EXIT.
.
.
and .
Cont
and .
or .
. BUTTON PROGRAMMED! is
.
.
15-601124 Issue 05a (16 July 2009)
or
Page 50