Longhand Programming; 4610 And 5610 User Guide - Avaya 4610 User Manual

4610 and 5610 User Guide

Longhand Programming

1. Press Admin or
2. To switch to longhand programming mode, press Expl?
3. Press Next
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter
the data using the normal phone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each
.
6. To move between the pages of display keys, press
7. To select the display key against which to program the new function, press
Caution

Do not select the slot used for the Admin function. Replacing this function will lock the
phone for further programming until reset through the phone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.

To end programming, press

To continue programming other functions, press
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press
display.

To replace that existing function with the one just programmed, press Repla
BUTTON PROGRAMMED! is displayed.

To keep the existing function and forget the function just programmed, press Keep

To delete the existing function and forget the function just programmed, press Delete
4610 and 5610 User Guide
IP Office 3.2
Admin 1.
until the function required is shown, then press Selct
or until Repla, Keep and Delet are shown along the right-hand edge of the
.
and
Phone/Exit.
Cont
.
.
or
[15-601080] Issue [3] (5 June 2006)
and
.
.
.
.
Page 34