Rear View - ATEN KL1108V User Manual

KL1108V / KL1116V User Manual

Rear View

1 2 3 4
7
No. Component
1 Grounding
Terminal
2 Power Socket
3 Power Switch
4 PON Port
5 Serial 2 Port
6 LAN 2 Port
7 Modem Port
8 Serial 1 Port
9 LAN 1 Port
10 Local Console
Port Selection
11 KVM Port
Selection
* The KL1116V is pictured above. The KL1108V rear panel is the same as that
of the KL1116V, except that it has 8 KVM ports instead of 16.
15
5 6
10
8 9
The grounding wire used to ground the switch attaches here.
This is a standard 3-pin AC power socket. The power cord
from an AC source plugs in here.
This is a standard rocker switch that powers the unit on and
off.
This connector is provided for a Power over the Net™ (PON)
unit to plug into. A PON device allows computers attached to
the KL1108V / KL1116V to be booted remotely over the net.
Contact your dealer for more details.
This port can be used to connect a serial device.
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
For dial in connection should the unit be unavailable over the
network. See Single Stage Installation, page 27, step 7 for
installation details.
This port can be used to connect a serial device.
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
If this is a Single Station installation, or if you would like to
connect an external console, the keyboard, monitor, and the
mouse that make up the Local Console plug in here.
The Cat 5e/6 cables that link to the KVM Adapter Cables
(which link to the computers) plug in here.
11
Description