Blade Server Setup - ATEN KL1108V User Manual

Blade Server Setup

Adding a Blade Server
To configure a new Blade server, do the following:
1. Select its icon in the Sidebar, then click Add in the main panel. The Setup
Blade Server dialog box comes up, with the Step 1 tab displayed:
2. Fill in the fields according to the information provided in the table, below:
Field
Server Model
Include KVM
Server Name
Server IP
Service Port
User Name
Password
Scan Interval
Drop down the list to select the blade server chassis model. If
your model isn't included in the list of supported servers, contact
your dealer for help.
This item is for information purposes and can't be edited. If the
server supports a KVM function, this box is checked. Otherwise,
it is unchecked.
For convenience, you can give the server a name.
Key in the server's IP address (IPv4, IPv6, or domain name)
used to access the server via a serial connection (Telnet or
SSH)
Key in the port number used for serial access.
Key in the username required for serial access authentication.
Key in the password required for serial access authentication.
The interval between times that the KVM over IP switch scans
the server for information.
Chapter 9. Device Management
Explanation
188